Front Panel of the vEdge 100m Routerįigure 2. Status indicators, and chassis identification labels.įigure 1. The following figures show the front and back panels of the vEdge 100m router, indicating the locations of the power interfaces, Kensington security lock slot to physically lock down the router Secure identification chip for anticounterfeit and secure authentication Power over Ethernet (PoE) source support on one Ethernet portĥ0-Mbps of unidirectional Internet Mix (IMIX) forwarding traffic (inclusive of encryption)
Supports a 4G/3G/2G–capable modem to connect to cellular networksįive built-in 10/100/1000–Mbps Ethernet ports Two multiband swivel-mount dipole antennas VEdge 100m router is a fixed-port-configuration router with the following features:īuilt-in LTE modem with mini-SIM (or 2FF) card
#MOUNTING PUTTY TO ROUTE CORDS MANUAL#
The temperature and humidity during transportation must comply with the permissible established ranges of temperature and humidity during storage (in the off state) specified in the Operation Manual (Installation).įor additional information on Meraki hardware and for other installation guides, please refer to vEdge 100m router delivers highly secure site-to-site data connectivity to small business and home offices (SOHO).
Transportation of equipment should be carried out in the original packaging in covered vehicles by any means of transport. The permissible temperature and humidity ranges during storage are specified in the Operation (Installation) Manual. The equipment should be stored in its original packaging in a room protected from atmospheric precipitation. The technical equipment is subject to storage and disposal in accordance with the organization's disposal procedure. Do not throw in the device with household waste. Disposal of a technical device at the end of its service life should be carried out in accordance with the requirements of all state regulations and laws. Rules and conditions for the sale of equipment are determined by the terms of contracts concluded by Cisco or authorized Cisco partners with equipment buyers. The equipment is subject to installation and maintenance by specialists with the appropriate qualifications, sufficient specialized knowledge, and skills. The equipment is intended for operation without the constant presence of maintenance personnel. The equipment is not for domestic use. The equipment is used in areas without exposure to harmful and dangerous production factors, unless otherwise specified in the operational documentation and/or on the equipment labeling. The equipment is intended for industrial or other commercial activities. If issues are encountered with device installation or additional help is required, contact Meraki Support by logging in to and opening a case by visiting the Get Help section. Please only power the device with the provided power cables to ensure regulatory compliance. Ensure that the protective device is rated not greater than: 15 A, 125 Vac, or 10A, 240 Vac. This product relies on the building’s installation for short-circuit (overcurrent) protection. Failure to use the correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system. Read the mounting instructions carefully before beginning installation. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Power off the unit before you begin. Read the installation instructions before connecting the system to the power source. 
Please take the following into consideration for safe operation:
These operations are to be taken with respect to all local laws. Warning: The system must be disconnected from all sources of power and the power cord removed from the power supply module(s) before accessing, installing, or removing system components.Ĭaution: The Optical Transceiver product should use UL listed, and Rated Laser Class I, 3.3Vdc.
0 kommentar(er)
